Dupla pH-Control Pro - Ph Programming; Ph Set Pointprogramming

10
5.2 pH programming
pH
pH
pH
Note: The pH control is an alternative programming for temperature 1 in slot 1.
After acknowledging flashing
, pH is displayed and SET flashes.
If you want to programme the pH Set point, press . Proceed making your settings as in item 5.2.1 of the instruc-
tions.
If you want to activate the night off function press another time the ▼, button until flashes and confirm by
pressing the button. Continue making your settings with item 5.3.2 of this instructions.
If you want to programme the pH alarm, press the ▼ button again until
flashes and confirm by pressing the
button. Proceed making your settings with item 5.2.3 of the instructions.
If you want to (de)activate the audible alarm function, press the ▼ button again until flashes and confirm by
pressing the button. Proceed making your settings with item 5.2.4 of the instructions.
If you want to calibrate your pH-Electrode, press the ▼ button to select CAL and confirm by pressing the
button. Proceed making your settings with item 5.2.5 of the instructions.
If you want to (de)activate the pH Calibration reminder, press the ▼ button again until CAL and
flash and confirm
by pressing the button. Proceed making your settings with item 5.2.6 of the instructions.
5.2.1 pH set point programming
pH
pH
pH
When or your last set value and pH are flashing, press the button to set the pH point.
When flashes, press the button to confirm.
When or your last set value flashes, use the ▲ or ▼ button to set the desired pH value between and ,
and acknowledge with .
Please note: The pH Set Point presetting is
. Depending on water values where your fish come from, higher
or lower values could be required.