Dupla pH-Control Pro - 4 Quick Start Guide to Programming

pH-Control Pro Main Menu
Clock
programming (5.1)
Slot 1
programming:
pH (5.2)
Time
setting (5.1.1)
(De-)activation of the
audible pH alarm (5.2.4)
Slot 2
programming:
Timer (5.3)
Setting the
timer control mode
(5.3.1)
Either
up to 8 ON / OFF
times
or
interval
or
permanent ON
pH Electrode
Calibration (5.2.5)
Calibration Reminder
(de-)activation (5.2.6)
Programming interval
control (5.3.3)
Programming turn-on
and turn-o times (5.3.2)
CO
2
Night Function (5.2.2)
pH Alarm
programming (5.2.3)
pH
Set point (5.2.1)
8
4. Quick start guide to programming
Audible acknowledgment: Press a button briefly, i.e. a ‘tap’ = short sound. Hold a button down, i.e.
for 3 seconds = long sound.
Switching to programming mode: A) Pressing the
button enters the main programming menu.
Moving within the main [sub] menu structure:
B) With the ▲ or ▼ buttons you can scroll through the menu items. Short
pressing of
acknowledges the selection which sub menu item to
access. As well in the sub menu structure you can scroll through the menu
items with the ▲ or ▼ buttons and you acknowledge a selection by short
pressing of .
Modifying programming: C) Pressing
enables the modification of programmed values, the
changeable value flashes. D) Increase or decrease required values with the
▲ or ▼ button. E) Acknowledge by activating the button.
Quitting the submenu structure: F) By holding down the
button for 3 seconds you switch from a
lower to a higher menu level.
Quitting the programming mode: G) After 90 seconds of inactivity you automatically access the operational
mode. From the main level you can access the operational mode as well by
holding down the
button for 3 seconds. All changed values will be
saved.
Cancelation of programming: By pressing the ▲ and ▼ button simultaneously it is possible to quit the
programming mode at any time without saving.