Duplo Duprinter DP-43E - Removing the Jam Sensor (Photo-Receiving PCB Unit); Removing the Belt Motor

197
n Paper Ejection Section
chap.3
(5) Removing the Belt Motor
1) Remove the paper ejection fan unit.
2) Pull the paper ejection belts wider apart to
expose the screws, and secure the belts in that
position.
3) Remove the 2 screws securing the sensor mount-
ing angle, and remove the angle.
4) Remove the 2 screws from the sensor PCB, and
remove the PCB.
: Do not lose the 2 spacers.
IMPORTANT
1) Remove the paper ejection fan unit.
2) Loosen the set screw, and remove the encoder.
3) Remove the 3 screws from the motor, and remove
the belt motor.
Remove the 2 screws with a driver
Paper ejection belts
Sensor PCB
Screws
Spacers
Set screw
Encoder
Timing belt
Screws
Motor
\See page 195
\See page 195
(4) Removing the Jam Sensor (Photo-
receiving PCB UNIT)