Chap.1 ⁄0 Error Messages and Corrective Action
59
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Raise the top cover release lever to open the
scanner unit.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Remove the master left in the master feeder.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Gently close the scanner unit and press it until
it locks.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Check that the error message is deleted.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Make a new plate and start printing.
IMPORTANT
• The message “CANNOT PRINT” is displayed on the LCD panel when (PRINT) key is
pressed without platemaking being carried out.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Lever
Scanner unit
(9) Master set Incorrectly
To Next Page
Loading...
