What to do if E001 is displayed on Duplo Printer?
If error code E001 appears on your Duplo Printer, check the encoder sensor position. If the sensor position is OK, the cause might be a faulty Main PCB Unit, which should be replaced. You can also remove the interference or the cause. Check the bundled wire and connector; if they are OK, replace the main PCB. You can also follow the procedure (5) or finish.
How to fix E003 error on Duplo Duprinter DP-43S Printer?
To address error E003 on your Duplo Printer, start by removing any jammed master. Then, check the bundled wire and connector; if they appear to be in working order, replace the main PCB. Other possible solutions include following procedure (5), replacing the cutter motor, or addressing the regulated power supply.
What to do if Duplo Duprinter DP-43S displays E002?
When your Duplo Printer shows error E002, first, remove the cause of defective operation, such as leaning or catching. If the elevator top limit sensor is defective, follow procedure (6). If the problem persists, consider replacing the regulated power supply, the elevator, the elevator motor, the main PCB Unit, or the elevator top limit sensor. If the Elevator bottom limit switch is the cause, replace the elevator bottom limit SW.
How do I fix E006 error on my Duplo Printer?
To resolve the E006 error on your Duplo Printer, first try following procedure (5). If that doesn't work, check the bundled wire; if it's OK, replace the contact pressure motor. You can also try replacing the regulated power supply or the main PCB. Alternatively, you can finish.
What should I do if my Duplo Duprinter DP-43S shows E008?
If your Duplo Printer displays E008, you can try to finish, or replace the Main PCB Unit.
Detailed technical specifications for different models of the Duprinter.
Illustrates the setup of the machine and its optional equipment.
Provides step-by-step instructions for printing and other operations.
Lists common error messages and their corresponding corrective actions.
Covers the removal of the cutter unit, thermal head, and master feed unit.
Covers tension adjustments for timing belts and master feed unit.
Details adjustments for paper switch, separator unit, and feed tray.
Provides safety precautions and unpacking checks for installation.
Covers preparation and setting of the drum unit and ink pack.
Provides countermeasures for defective image and operation issues.
Lists error codes, their causes, and detection timing.
To Next Page
General