HELP
Mode No.
Description Classification Page
H-00
(1) Display of ROM versions
(2) Main PCB ROM version upgrade procedure
(3) Editing control PCB ROM version upgrade procedure
ROM version
displays/upgrading
(1) 292
(2) 293
(3) 294
H-01
(1) Print speed adjustment
(2) Ejection belt speed adjustment
(3) Function testing of ink roller rise/descent motor
(4) Function testing of contact pressure motor
Adjustment/specification
setting
Function testing
(1) 296
(2) 298
(3) 299
(4) 299
H-02 (1) Elevator motor function testing Function testing 300
H-03 (1) Tape cluster function test Function testing 301
H-04 (1) Ink replenishment function testing Function testing 302
H-05
(1) Checking of condition of master ejection sensor and other sensors
listed below
¡Master ejection sensor
¡Top/Bottom limit sensor, top /Bottom center sensor,
Document cover sensor, Home position sensor
Sensor/switch condition
display
303
H-06
(1) Checking of condition of sensors listed below
¡Drum master attachment /detachment position sensor,
Paper ejection jam sensor, Drum stop/paper ejection jam
Paper sensing position sensor, Press roll sensor
¡Encoder sensor, Elevator top limit sensor, A/C mode sensor,
B mode sensor
Sensor/switch condition
display
304
H-07
(1) Checking of condition of switches listed below:
¡Drum rotation switch, Cutter limit switch(inner),
Cutter limit switch(operation side)
¡Drum cover switch, Master attachment switch,
Sensor/switch condition
display
305
H-08
(1) Checking of condition of switches listed below:
¡Drum switch,Paper roll FULL switch,
Scanner unit open / closed detection switch
Sensor/switch condition
display
306
H-09
(1) Checking of master attachment position, jam sensing position,
master detachment position and drum stop position
Function testing 307
H-10 (1) Testing of functioning of indicators (on/off) and optical system Function testing 308
H-11
(1) Display of document size and document darkness values
(for use in factory checks)
Sensor/switch condition
display
309
H-12
(1) Checking of AD PCB unit shading memory, thermal head and main
PCB unit synchronized signals; display of thermistor temperature;
display of time elapsed since last print run
Function testing 311
H-13
(1) Check the condition of the contact pressure upper limit switch,
contact pressure center limit switch, contact pressure lower
limit switch, ink roller rise / descent switch, and check displays of
amount of light received by end mark sensor.
Sensor/switch condition
display
313
To Next Page
Loading...
