206
m Print Tray Section
chap.3
(6) Removing the Inner Frame
1) Remove the outer frame (right) unit.
2) Loosen 2 set screws on the supporting plate,
move the supporting plate in the direction of
arrow until it stops and fix it with the screw.
3) Pull out the inner frame (section inside the
drum) in the direction of an arrow.
: Be careful not to damage the drum
inside.
IMPORTANT
Slide the supporting plate in the direction of arrow
1 so that the supporting plate roller, roller unit and
roller are in contact with the inner surface of the
flunge right and tighten the roller with the screw,
pressing the roller to the inner surface lightly.
Screws
Roller
Roller
Suporting
plate
Roller unit
Roller
\See page 204
Reinstallation
To Next Page
Loading...
Need help?
General