Duplo Duprinter DP-43S - Master Clump Opening;Closing Section; Adjusting the Timing Belt Tension; Positioning the Master Clump Opening; Closing Levers

217
x Plateaking / Master Feed / Ejection Sectin
chap.4
Adjustment procedure
1) Loosen the tension set screw.
2) Apply a force of about 1.0kg in the direction of
the arrow to tension the belt, then tighten the
set screw.
After Adjustment
: Be sure to adjust the A/B/C mode
after installation to the printer.
IMPORTANT
1. Paper feed master clump opening/closing lever
When tensioning the timing belt, ensure that the
subframe is positioned so that the upper surface of
the master clump opening/closing lever is aligned
(to within 0.5mm) with the rim of the positioning
hole.
2. Paper ejection master clump opening/closing
lever
When tensioning the timing belt, ensure that the
master clump opening/closing lever is co-centered
with the subframe's positioning holes.
Master clump opening / closing lever
Positioning hole
Tension
1.0kg
Screw
Master clump opening / closing lever
Positioning hole
Paper feed master clump opening/closing lever
Paper ejection master clump opening /
closing lever
Tension
Angle
Positioning hole
Positioning hole
Subframe
Positioning hole
Aligned (to within 0.5mm)
Paper feed master clump opening/closing lever
Paper ejection master clump opening/closing lever
Subframe
Positioning hole
Positioning hole
Angle
Master Clump Opening/Closing Section
(1) Adjusting the Timing Belt Tension
(2) Positioning the Master Clump
Opening / Closing Levers
¡For removal of master clump opening / closing unit.
NOTE
After Adjustment
: Be sure to adjust the A/B/C mode
after installation to the printer.
IMPORTANT
\See page 186
¡For removal of master clump opening / closing unit.
NOTE
\See page 186