Duplo Duprinter DP-43S - Platemaking; Master Feed and Ejection Section; Master Feed Section; Removing the Cutter Unit

180
c Platemaking/Master Feed and Ejection Section
chap.3
c Platemaking / Master Feed and Ejection Section
(1) Removing the Cutter Unit
1) Lift up the scanner unit and remove the roll mas-
ter.
2) Remove the cover's screw, and remove the cover.
3) Remove the 2 connectors.
4) Remove the 2 cover mounting screws, and remove
the cover.
5) Remove the 2 screws from the cutter unit, and
remove the cutter unit.
2 connectors
Screw
Screw
Cover
Cutter unit
Cover
Screw
Top cover release lever
Screw
Screw
Master Feed Section
43SH0327
43SH0328