213
z Scanner Section
chap.4
(2) Determining the Slider A / B Position
1) Tighten the screws of the wire clump on Slider A at the position where sliders A and B and frame position
hole are in alignment, and fix the wire.
(3) Adjusting the Timing Belt Tension
Adjustment procedure
1) Loosen 3 screws and tighten them to produce a
suitable tension as the spring works.
Slider B
Screw
Screws
Spring
Slider A
Wire clump
¡For removal of optical system driving unit.
NOTE
\See page 177
Screw
Position hole
Wire clump
Slider A
Screw
To Next Page
Loading...
