37
Chap.1 . Operation Procedures
2in1
2in1
In the normal state (when the ADF is not connected) the mode is switched by pressing the
multiple printing selection key as follows.
Every time the key is pressed, the mode is switched
and the relevant multiple printing indicator lamp
lights up.
• Each press of the multiple printing selection key makes
a different multiple printing indicator light up, in
sequence. To set the number of images, press the key
until the indicator for the desired number of images is
lit.
When the ADF is connected, the multiple printing selection key can also be used to select
the 2 in 1 Layout Mode, as shown below. To activate the 2 in 1 Layout Mode, press the key
until the " " icon is lit.
2in1
<<S type models>>
To Next Page
Loading...
Need help?
General