Duplo Duprinter DP-43S - Fine Start Mode Data

159
m Drum Section
chap.2
1. Fine Start Mode Data
The chart below shows the relations among elapsed time, temperature, number of no-paper revolutions,
contact pressure, and first sheet printing speed.
*Figures for number of no-paper rotations do not include no-paper rotations for ink supply prior to printing
start.
*These data were current as of the main PCB unit's ROM (Ver. 1.31 or later), and are subject to change.
HELP59 Fine Start Mode
elapsed time setting
Auto 6 hrs
12 hrs
Temp.
Elapsed time
0 to 0.5 hrs 0.5 to 2 hrs 2 to 5 hrs 5 to 12 hrs Over 12 hrs
Up to 7°C
Before master detachment
4
3303
Before master attachment
4
3335
After master attachment 5 3 3 6 5
7 to 12°C
Before master detachment
4
3
444
Before master attachment
4
5
4
35
After master attachment 3 5 6 3 5
12 to 17 °C
Before master detachment
44444
Before master attachment 1
444
3
After master attachment 1 3 5 5 5
17 to 22 °C
Before master detachment
44444
Before master attachment 1
444
3
After master attachment 1 1 3 4 3
22 to 27°C
Before master detachment
44444
Before master attachment 1
444
3
After master attachment 3 3 4 6 3
27 to 32°C
Before master detachment
44444
Before master attachment
4444
3
After master attachment 3 4 5 5 3
Over 32°C
Before master detachment
44444
Before master attachment
4444
3
After master attachment 3 3 5 5 5
HELP mode H-59 \ see p.358