Duplo Duprinter DP-43S - Removing the Lens Cover; Removing the a; D PCB Unit

176
x Scanner Section
chap.3
(8) Removing the Lens Cover
(9) Removing the A / D PCB Unit
1) Remove the glass.
2) Remove the screw.
3) Slide the lens cover in the direction of an arrow
to remove.
1) Remove the lens cover.
2) Pull out connector CN1 and CN2.
3) Remove 2 screws and 2 spacers to take out the A
/ D PCB Unit.
Lens cover
Screw
Lens
CCD PCB unit
CN1
CN2
A / D PCB unit
Screws
\See page 173
¡After replacing an A / D PCB unit, return the DIP
switches to the values they were set to prior to
the replacement operation.
Reinstallation
IMPORTANT
For adjustment procedure \ see p. 244
After replacing an A / D PCB unit, return
the DIP switches to the values they were
set to prior to the replacement operation.
43SH0369
Spacers