HELP
Mode No.
Description Classification Page
H-14
(1) 6-digit display of count of total plates made, divided into 2 higher-
order digits and 4 lower-order digits
(2) Resetting of count of total plates made in user mode
Total counts
(1) 314
(2) 315
H-20
(1) Function testing of clump motor and clump position sensing
(A/B/C mode position)
Function testing 322
H-23 (1) Setting of photograph mode document sensing darkness
Adjustment/specification
setting
327
H-24
(1) Setting of lengthwise zoom factor correction amount
for sensing side
Adjustment/specification
setting
328
H-25
(1) Compensation of document darkness white level when ADF is
used
Adjustment/specification
setting
329
H-26
(1) Compensation of document darkness white level in photograph
mode
Adjustment/specification
setting
330
H-27 (1) Initialization of all HELP mode settings
Adjustment/specification
setting
331
H-28
(1) Setting of tape cluster presence/absence, buzzer selection
and key card specification
Adjustment/specification
setting
332
H-29 (1) Adjustment of paper infeed amount
Adjustment/specification
setting
333
H-30
(1) Test pattern (front shading, poor image area checking, secondary
scanning direction zoom factor adjustment) platemaking and
printing
Function checking 334
H-31 (1) Setting of number of pre-print sheets
Adjustment/specification
setting
336
H-32
(1) Selection of first print speed, setting of master ejection error
sensing, selection of sort mode
Adjustment/specification
setting
337
H-33 (1) Compensation of document darkness white level in text mode
Adjustment/specification
setting
338
H-34 (Not used)
44
H-35 (1) Scanner leading edge sensing position adjustment
Adjustment/specification
setting
339
H-36 (1) Scanner widthwise (operation side) sensing position adjustment
Adjustment/specification
setting
340
H-21
(1) Display of ADF communication status and error codes
(2) Function testing of single and continuous feed by ADF
ADF error code display
Function testing
(1) 323
(2) 325
H-22
(1) Setting of lengthwise zoom factor correction amount for
platemaking side
Adjustment/specification
setting
326
H-19
(1) 7-digit display of count of total sheets printed, divided into 3 higher-
order digits and 4 lower-order digits
(2) Resetting of count of total sheets printed in user mode
Total counts
(1) 320
(2) 321
H-18 (1) Function testing of roll-up motor Function testing 319
H-17 (1) Function testing of cutter motor Function testing 318
H-16 (1) Correction of platemaking start position during online platemaking
Adjustment/specification
setting
317
H-15 (1) Function testing of ink motor Function testing 316
To Next Page
Loading...
