Duplo Duprinter DP-43S - Page 288

288
z Help mode List
chap.7
HELP
Mode No.
Description Classification Page
H-40 (Not used)
44
H-41
(1) Changing of platemaking start position for second image in multiple
image printing, setting of repeat count display, selection of sorter
home position timing
Adjustment/specification
setting
342
H-45 (1) Setting of special paper size length
Adjustment/specification
setting
346
H-46 (1) Setting of special paper size length
Adjustment/specification
setting
346
H-47 (1) Setting of special paper size width
Adjustment/specification
setting
348
H-48 (1) Setting of special paper size width
Adjustment/specification
setting
349
H-56 (Not used)
44
H-57 (1) Setting of online conditions
Adjustment/specification
setting
353
H-58 (Not used)
44
H-59
(1) Setting of: intermittent paper feed mode, master clump
application/release timing for master attachment, count change
when ink is absent, fine start mode ON/OFF
Adjustment/specification
setting
358
H-49 (1) Adjustment of sensing side widthwise zoom factor
Adjustment/specification
setting
350
H-50 (1) Setting of text mode document sensing darkness
Adjustment/specification
setting
351
H-51 (1) Setting of darkness for test pattern platemaking
Adjustment/specification
setting
352
H-52 (1) Setting of online conditions
Adjustment/specification
setting
353
H-53
(1) Adjustment of widthwise (operation side) platemaking start position
for online platemaking
Adjustment/specification
setting
355
H-54 (1) Function testing of main PCB unit sorter port
Adjustment/specification
setting
356
H-55
(1) Setting of ink check at printing start, cutting operation mode
for master cutting, and interlocks
Adjustment/specification
setting
357
H-42 (1) Setting of paper selection specification
Adjustment/specification
setting
343
H-43 (1) Setting of thermal head resistance ranking
Adjustment/specification
setting
344
H-44 (1) Setting of thermal head resistance ranking
Adjustment/specification
setting
344
H-37 (1) Adjustment of platemaking start position when scanner is used
Adjustment/specification
setting
341
H-39 (Not used)
4 4
H-38 (Not used)
4 4