HELP
Mode No.
Description Classification Page
H-60
(1) Selection of operation panel auto clear activation timing, and
duration of fine start mode
Adjustment/specification
setting
359
H-61 (1) Selection of LCD specification
Adjustment/specification
setting
360
H-62
(1) Selection of: operation stop after printing of 1 sheet after
platemaking; tape insertion timing; and display of list of numbers of
sets and sheets
Adjustment/specification
setting
361
H-63
(1) Setting of: use of scanner pulley unit; factory adjustment value; use
of A4 drum: and maximum value for user-set zoom factor
Adjustment/specification
setting
362
H-64
(1) Setting of calling up of memory M1 (DP-**S) / function F1 (DP-**E)
data when power turned on (when sorter present / absent), and
length of long tape for tape cluster
Adjustment/specification
setting
363
To Next Page
Loading...
Need help?
General