Duplo Duprinter DP-43E - Page 359

359
c HELP Mode Function and Operation Procedures
chap.7
H-60
(1) Adjustment / specification settingHELP mode
1. Functions
(1) Selection of operation panel auto clear activation
timing, and duration of fine start mode
2. Operation procedures
Display Item Setting
0 0
**
Selection of time for opera-
tion panel auto clear function
OFF
0 1
**
3 minutes
1 0
**
10 minutes
1 1
**
15 minutes
**
0 0
Selection of time for Fine
Start Mode
Deactivated
**
0 1 6 hours
**
1 0 12 hours
**
1 1 Auto
0 0 0 0 Factory setting
- L -
****
Correction amount display
During memorization:
(1) Selection of operation panel auto clear activation
timing, and duration of fine start mode
qAccess HELP mode H-60, and press the PRINT key.
For the basic procedure for accessing HELP modes.
wUse the [0] and [1] numeric keys to enter a 4-place binary value for
the desired correction amount. See the table below for 4-place
binary values and the corresponding correction amounts.
rPress the STOP key. The HELP mode selection display will
reappear.
a To exit the HELP mode : Turn the power switch OFF.
a To access another HELP mode : Enter the desired mode number
using the numeric keys.
ePress the [=] key. The correction amount will be memorized
in the battery PCB unit's EEPROM. During memorization, "-L-"
will be displayed.
Do not turn off the power before the "-L-" display has disappeared.
IMPORTANT
\See page 291