DuraLabel PRO - B Mark Label Printing Instructions; Cutting Labels in Intervals

CONFIgURINg PRINTER DRIvERS
26
DuraLabel.com 800.788.5572
6.3 B Mark Label Printing Instructions
6.3.1 LABEL SUPPLY CALIBRATION
Label supply must be calibrated to print B Mark labels.
A. With the power OFF, hold the Feed button down while turning ON the printer. The
LED will flash red 5 times, amber 5 times, green 5 times, alternating green and
amber 5 times, alternating red and amber 5 times and then turn solid green.
B. Release the Feed button while the LED blinks green and amber.
C. Follow directions in Section 6.3.2, Driver Settings.
6.3.2 DRIVER SETTINGS
Your printer driver has been preset to reduce the
number of steps to be completed manually. You
can change your settings by following these steps:
A. For B Mark labels, select Labels With Marks
from the Type drop-down menu.
B. Set Mark Height to 0.12 inches and Mark
Offset to 0 inches (default).
C. Click Apply, then OK.
FIGURE 5 Printing Preferences dialog box,
with Type set to “Labels With Marks”
FIGURE 6 Printing Preferences dialog box, with Occurrence set to
“After Specied Interval”
6.4 Cutting Labels in Intervals
To cut labels in intervals, set “Occurrence” to After
Specified Interval. Set the interval to the number
of labels needed, then click Apply to save your
settings.