What to do if DURASTAR DRAF18F1A Air Conditioner's evaporator coil inlet temperature sensor T2 is in open circuit or has short circuited?
If your DURASTAR Air Conditioner's evaporator coil inlet temperature sensor T2 is in open circuit or has short circuited, refer to service solution TS05-IDU.
What to do if my DURASTAR DRAF18F1A starts and stops frequently?
If your DURASTAR Air Conditioner is starting and stopping frequently, it could be due to several reasons. The system might have too much or too little refrigerant, in which case you should check for leaks and recharge it. There might be incompressible gas or moisture in the system, requiring evacuation and recharge. A broken compressor or voltage issues could also be the cause. In the latter case, consider installing a manostat to regulate the voltage.
Why is my DURASTAR Air Conditioner's heating performance poor?
If your DURASTAR Air Conditioner isn't heating well, it could be due to extremely low outdoor temperatures, in which case you may need to use an auxiliary heating device. Cold air entering through doors and windows can also affect performance; make sure they are closed. Additionally, low refrigerant due to a leak or long-term use could be the issue; check for leaks, reseal if necessary, and top off the refrigerant.
What to do if indicator lamps continue flashing on my DURASTAR DRAF18F1A?
Wait about 10 minutes to see if the problem resolves itself. If the flashing continues, disconnect the power, then reconnect it and turn the unit on. If the problem persists, disconnect the power and contact your nearest customer service center.
What to do if DURASTAR Air Conditioner's indoor fan speed is operating outside of the normal range?
If your DURASTAR Air Conditioner's indoor fan speed is operating outside of the normal range, refer to service solution TS04-L- IDU.
What does it mean if my DURASTAR Air Conditioner displays indoor unit EEPROM parameter error?
If your DURASTAR Air Conditioner is showing an indoor unit EEPROM parameter error, refer to service solution TS01-IDU.
What to do if DURASTAR Air Conditioner's outdoor room temperature sensor T4 is in open circuit or has short circuited?
If your DURASTAR Air Conditioner's outdoor room temperature sensor T4 is in open circuit or has short circuited, refer to service solution TS05- ODU.
What does it mean if my DURASTAR DRAF18F1A displays outdoor unit EEPROM parameter error?
If your DURASTAR Air Conditioner is showing an outdoor unit EEPROM parameter error, refer to service solution TS01- ODU.
What does it mean if my DURASTAR DRAF18F1A displays IPM malfunction or IGBT over-strong current protection?
If your DURASTAR Air Conditioner is experiencing IPM malfunction or IGBT over-strong current protection, refer to service solution TS09-L.
What to do if DURASTAR Air Conditioner displays current overload protection?
If your DURASTAR Air Conditioner is showing a current overload protection error, refer to service solution TS08-L- INV.
General| Brand | DURASTAR |
|---|---|
| Model | DRAF18F1A |
| Category | Air Conditioner |
| Language | English |
To Next Page
