What does it mean if my DURASTAR DRAF18F1A displays IPM malfunction or IGBT over-strong current protection?
If your DURASTAR Air Conditioner is experiencing IPM malfunction or IGBT over-strong current protection, refer to service solution TS09-L.
What to do if DURASTAR DRAF18F1A Air Conditioner displays over voltage or over low voltage protection?
If your DURASTAR Air Conditioner is showing an over voltage or over low voltage protection error, refer to service solution TS10-L.
What to do if DURASTAR Air Conditioner displays current overload protection?
If your DURASTAR Air Conditioner is showing a current overload protection error, refer to service solution TS08-L- INV.
What to do if my DURASTAR Air Conditioner doesn't respond to the remote control?
If your DURASTAR Air Conditioner unit isn't responding to the remote control, the indoor PCB may need to be replaced.
What to do if indicator lamps continue flashing or error code appears on DURASTAR Air Conditioner?
If the indicator lamps on your DURASTAR Air Conditioner continue to flash or error codes appear, wait for about 10 minutes to see if the problem resolves itself. If not, disconnect the power, then reconnect it and turn the unit on. If the problem persists, disconnect the power.
How to improve heating performance of my DURASTAR Air Conditioner?
If your DURASTAR Air Conditioner isn't heating well, especially when the outdoor temperature is extremely low, remember that its heating performance is impacted at temperatures below freezing. Ensure all doors and windows are closed to prevent cold air from entering. Low refrigerant levels can also affect heating, so check for leaks and refill if necessary.
Why does my DURASTAR DRAF18F1A start and stop frequently?
If your DURASTAR Air Conditioner starts and stops frequently, it may be due to several reasons. The system might have too much or too little refrigerant, so check for leaks and recharge the system. Incompressible gas or moisture might have entered the system, requiring evacuation and recharge. A broken compressor or voltage fluctuations could also be the cause. In the case of voltage issues, consider installing a manostat to regulate the voltage.
What to do if my DURASTAR DRAF18F1A Air Conditioner is not working?
If your DURASTAR Air Conditioner isn't working, start by checking for a power failure or if the power is turned off. Replace the fuse if it's burned out. If you're using the remote control, replace the batteries. Also, the unit might be under a 3-minute protection cycle, so wait three minutes after restarting. Make sure the timer is turned off.
What to do if indicator lamps continue flashing on my DURASTAR DRAF18F1A?
Wait about 10 minutes to see if the problem resolves itself. If the flashing continues, disconnect the power, then reconnect it and turn the unit on. If the problem persists, disconnect the power and contact your nearest customer service center.
Why is my DURASTAR Air Conditioner's heating performance poor?
If your DURASTAR Air Conditioner isn't heating well, it could be due to extremely low outdoor temperatures, in which case you may need to use an auxiliary heating device. Cold air entering through doors and windows can also affect performance; make sure they are closed. Additionally, low refrigerant due to a leak or long-term use could be the issue; check for leaks, reseal if necessary, and top off the refrigerant.
General| Brand | DURASTAR |
|---|---|
| Model | DRAF18F1A |
| Category | Air Conditioner |
| Language | English |
To Next Page
