Page | 68
GENERAL MAINTENANCE
These are the specifications for a standard machine. Please refer to the mechanical layout and electrical schematics
for your exact machine specifications.
-Electrical: 230Vac/3 phase/60Hz – 13 Amps
-Pneumatic: 3CFM @ 80PSI - clean dry air
-Lube station grease (Ring gear bearing): Unirex EP2, Esso or equivalent
-Pinion and ring gear teeth grease: Unirex EP2, Esso or equivalent
-Reducer oil: Mobil Glygoyle 460
-Chain grease: Unirex EP2, Esso or equivalent
Warning! Any suspended mass part of the wrapping/strapping equipment must be secured (using chains or belts,
resting on an easel, etc.) at all times during maintenance or repair works, even when machine power is out, in order
to avoid unexpected or involuntary movements of the equipment. Failure to comply with this warning may cause
severe injuries or death to nearby workers or damages to the machine.
ACTIVE MAINTENANCE OPTION
If the machine is equipped with the active maintenance option, maintenance warnings will be displayed on the HMI.
Follow the instructions on the HMI to achieve proper maintenance. If the machine is not equipped with this option,
refer to the maintenance instructions or the preventive maintenance calendar in the following pages.
To Next Page
Loading...
