DURAVIT SensoWash Slim - Page 37

37
EN
General function
SensoWash
®
is
not working.
SensoWash
®
is
not switched on.
(“Status LED”
B
is
not illuminated)
> Switch on the main
power supply.
SensoWash
®
is in
Standby mode.
(“Status LED”
B
is
red illuminated)
> Switch to “On
mode”.
6.1
A water leak
exists.
Malfunction. > Close the main
valve for the water
supply.
> Disconnect the
power supply.
> Call the installer.
Remote control
Icons on remote
control flash
during operati-
on. (instead of
beeing illumi-
nated)
The batteries
are low.
> Change the
batteries.
4.1
Problem Potential cause Solution Ch.