32
1.
4.
STARTING THE GENERATOR (CONTINUED)
Starting the Generator Using Recoil Start
Shut breaker o
The breaker is located on the right side of the front power
panel. Flip the breaker down to prevent accidental load
when starting the generator.
Turn engine switch to Run
The engine switch is located on the left side of the front
power panel. Press the engine switch to the RUN position.
Close choke
The choke lever is located above the air lter to the left of
the recoil start. Slide the lever to the left to cut the air supply
and allow more gas into the engine to start.
3.
Turn gas valve on
The gas valve is located above the recoil start on the bottom
of the fuel tank. Rotate the valve counterclockwise to the
vertical position to turn on the gas supply.
2.
To Next Page
Loading...
