- 14 of 23
Image Setup
The Image Setup menu allows you to position and adjust the video
image size. Video image parameters vary from different video sources
and must be adjusted to properly fit the screen.
To Adjust the Video Image Size and Position:
Select either the H-Position, H-size, V-Position or V-size option in
the Image Setup menu.
Use the left ◄ or right ► buttons to set the desired image size or
position.
Note: This Menu option is not available for the DVI inputs. The
position and size values are determined by the DVI source.
Image Setup
H-Position 230
H-Size 1876
V-Position 20
V-Size 535
New Video Source
The TransVision
™
3 determines the video signal type by measuring
horizontal and vertical scanning frequencies. If the video signal
matches a predefined video source, the TransVision
™
3 selects video
image settings from the system’s memory.
The predefined video sources include: 480i, 480p, 580i, 580p, 1080i,
540p, 720p, VGA, SVGA, XGA, and SXGA.
In addition to predefined video sources, the TransVision
™
3 allows the
user to create up to three new video source memory locations per video
input.
When a new video source is applied the TransVision
™
3 will display
New Video Source message. To create a new source memory, go to
the Image Setup menu.
Use the left ◄ or right ► buttons to select ‘Yes’.
Press ENTER.
Relay Setup
The Relay Setup allows you to assign the TransVision
™
3’s RY1 and
RY2 screen trigger outputs to particular aspect ratio for screen masking.
Off - Relay is off.
Power - Relay is on when the unit is on.
4:3 - Relay is on when 4:3 FORMAT is selected.
16:9 - Relay is on when Anamorphic or LetterBox Aspect
Ratios are selected.
Relay Setup
Relay 1 ◄Off ►
Relay 2 ◄Off ►
New Video Source
Highlight ‘Yes’ and
press ‘ENTER’ to save
No Yes
To Next Page
Loading...