Dwin TransVision 3 - AC Power Connection; Projector Installation Guide; Power Indicator Light

- 8 of 23
9. AC POWER RECEPTACLE
The AC power receptacle should
be connected to a non-switched 120 VAC outlet using the power
cord provided with the TransVision
™
3 system.
Installation of the TransVision
™
3 Projector
1. The AC power receptacle should be connected to a non-switched 120 VAC outlet using the power
cord provided with the TransVision
™
3 system.
2. The IR Sensor points toward the screen so that IR commands sent by the remote control are
received by the system. This sensor should not be covered to insure proper operation.
3. The Digital Input should be connected to the circular connector on DWIN’s DVI cable and the DVI-
D connector connected to the Digital Output on the back of the Digital Video Processor.
NOTE: For the TransVision
™
3 to operate correctly requires the use of a DWIN DVI cable
between the Projector and the Controller!
4. Do not drop the DVI connecter, because the shell can be easily deformed rending the connector
useless.
5. Do not coil, tightly bend or crimp the DVI cable, it may damage or short the wires and compromise
the shielding.
6. Do not straddle staple the DVI cable, it may puncture the cable, damaging or shorting the wires
and compromise the shielding.
7. When the DVI cable is being “pulled” or “snaked” DWIN recommends that the snake be connected
as far down the length of the DVI cable as possible to prevent stretching damage to the cable or
the connector.
8. To prevent interference, DWIN strongly recommends that the DVI cable not be run in close
proximity or tied to any AC power lines!
9. DWIN strongly recommends that the DVI cable be run through a dedicated (DVI cable only)
conduit that meets NEC or local electrical code requirements
.
10. The POWER LED is a multi-purpose indicator:
• When the LED is dark the AC power to the unit is turned off.
• When the LED is flashing on and off, power is connected and the unit is in the standby mode.
• When the LED is on the unit is powered on.
• When the LED is flashing fast, this indicates that the lamp is hot and the unit can not be turned
on. You need to wait approximately 1 minute to turn the unit on.