- 17 of 23
Note: that the ceiling mounting system enables you to make small adjustments to the vertical tilt
without introducing visible keystone distortion.
The TransVision
™
3 is a 16:9 Projector and is designed to be used with a 16:9 screen.
For floor-mounted installations the picture offset is the distance between the mounting surface of the
projector and the bottom of the picture. In order to deliver pictures that are free of keystone distortion,
be certain to calculate the offset distance before ordering screens and/or cabinetry. Although some
adjustment range is available in floor mounted systems by using the adjustable feet.
Ceiling Mount Preparation
Once the throw distance has been calculated and the screen installed, the next step in the installation
is to locate the precise mounting position of the projector.
IMPORTANT NOTE: Before proceeding further with the installation, make certain that video
signal/control wiring and AC power have been run to the projector location. Keep in mind that the
connections to the projector are at the front left side of the unit, looking from the front of the projector.
Place the signal and AC power cables slightly to the front and left side of the center of the projector.
The ceiling must be capable of safely supporting the weight of the projector and mount, which
is approximately 25 pounds.
Ceiling Mount Installation and Projector Mounting
The ceiling mount kit (CMB) consists of three parts. Before beginning
the installation process, first identify each of the three parts of the
mounting system as shown in the pictures on the right.
1. Disassemble the Ceiling Mount Kit by removing and saving the two
rear hex screws located on both sides of the Ceiling Mount Kit.
2. Loosen the middle two hex screws and slide out from the “L”
shaped groove brackets “A” and “B” as a unit.
3. On bracket “A”, remove and save all four hex head screws and
separate bracket “A” from bracket “B”.
4. Mount ceiling bracket “A” to the ceiling, making certain that the
“FRONT” label faces the screen.
5. Place bracket “B” inside bracket “A” and then secure the two pieces
together using the four hex head screws, making certain that the
“FRONT” label faces the screen.
6. Turn the projector upside down and place ceiling assembly C over
the bottom of the projector, with the “FRONT” label facing toward
the lens. NOTE: DO NOT ATTEMPT TO LOOSEN THE FIVE HEX
NUTS ON THE CEILING ASSEMBLY “C”, THEY ARE SEALED!
7. Use provided four .4” countersink screws to attach the ceiling
assembly “C” to the projector.
Ceiling Mount Kit
Ceiling bracket A
Ceiling bracket B
To Next Page
Loading...