Page 12
C otmd Counter Output Mode determines the output operation of the
control. It also determines how the counter will function after
reaching the set point. See the output mode charts on page 13 for
more information.
C SPEd Counting Speed can be set from one count per second up to
10,000 counts per second. This setting determines the minimum
input signal width.
t oUt1 Sets the pulse width (t) for output 1.
t oUt2 Sets the pulse width (t) for output 2.
Point Sets the number of digits to the right of the decimal point on the
display.
PSCALE Pre-Scale is used when converting the process value’s units of
measure. The pre-scale value would be set as the conversion factor.
(Pv = Pv * PSCALE)
PwErS Power Save feature allows the control to save the current process
value upon loss of power.
SAvE Save process value upon power loss
CLEAr Clear process value upon power loss
rtSr Minimum width of reset signal determines how long the reset
terminals must be engaged to reset the device.
inPtLC Input signal can be set for PNP or NPN. This parameter
determines which wiring diagram should be used.
To Next Page
Loading...
Need help?
General
