DX Engineering 4-BTV - Radial Plate to Mounting Pipe

- 33 -
Optional Radial Plate to Mounting Pipe
Install the optional DXE-RADP-3 Radial Plate on the 2" OD (maximum) customer supplied
mounting pipe using one optional DXE-SSVC-2P Stainless Steel V-Clamp as shown in the drawing
below. Mount the Radial Plate so you have approximately 1" of space between the bottom of the
plate and the ground level. This will allow easy access to install the radial wire hardware. The
DXE-RADP-3 Radial Plate comes with 20 sets of stainless steel hardware for mounting the radial
wires. Mount the plate as shown in relation to how the Tilt Base is mounted. (For reference, there
is a picture of a completed BTV base, with optional Tilt Base, Radial Plate and VFCC shown
below).
DXE-RADP-3
Radial Plate Installation
The picture to the right shows the Hustler
®
BTV base,
DXE-TB-3P Tilt Base
DXE-RADP-3 Radial Plate
DXE-VFCC-H05-A Vertical Feedline Choke
DX Engineering Radial Wires