Dymo 6000 - Preparing for use; Unpacking and Initial Setup

DYMO
®
6000 Labelmaker6
Preparing for use
Unpacking Remove the Labelmaker from the packaging carefully; observe any
warnings or packaging information. Retain all packaging for
possible future use.
Power Supply
The internal batteries will have been partially charged during
manufacture.
IMPORTANT: For maximum battery life, the internal batteries
should be charged for AT LEAST 24 hours before using the
machine on battery power for the first time.
Connect the round plug from the AC adaptor into the power input
socket on the Labelmaker (see Fig. 1), then plug the AC adaptor
into a convenient wall socket. Switch on at the wall socket and
leave it on charge for AT LEAST 24 hours.
You can use the Labelmaker with power from the AC adaptor
during the initial 24-hour charging period.
Fig. 1 — Rear/underside view
Connect the AC
adaptor plug here
External interface
socket