Dymo LabelManager 120P User Manual

13
Adjusting the Print Contrast
You can adjust the print contrast to fine tune the print quality of your label.
To set the contrast
Press 1. .
Select 2. Contrast and press }.
Use the arrow keys to select a contrast setting between 3. 1 (less contrast)
and 5 (more contrast), and press }.
Caring for Your Label Maker
Your label maker is designed to give you long and trouble-free service, while
requiring very little maintenance. Clean your label maker from time to time to
keep it working properly. Clean the cutter blade each time you replace the tape
cassette.
To clean the cutter blade
Remove the tape cassette.1.
Press and hold down the cutter lever to 2.
expose the cutter blade. See Figure 6.
Use a cotton ball and alcohol to clean both 3.
sides of the blade.
èThe cutter blade is extremely sharp. Use
caution when cleaning.
To clean the print head
Remove the tape cassette.1.
Remove the cleaning tool from inside the tape compartment cover. 2.
Gently wipe the padded side of the tool across the print head. See Figure 6.3.
Print head Cutter button
Figure 6
LM120P manual UK_WEU.indd 13 01-08-2007 10:13:25

Dymo LabelManager 120P Specifications

General

Maximum resolution	180 x 180 DPI
Tape size	9 mm
Label memory	1 label(s)
Battery type	AA
Number of batteries supported	6
Underline	Yes
Tape cutting	Manual
Number of fonts	1