5
About Your New Label Maker
With your new DYMO LabelManager
™
450D label
maker, you can create a wide variety of high-quality,
self-adhesive labels. You can choose to print your
labels in many different sizes and styles. The label
maker uses DYMO D1 label cassettes in widths of 1/4”
(6 mm), 3/8” (9 mm), 1/2” (12 mm),
3/4” (19 mm), or 1” (24 mm). Label cassettes are also
available in a wide range of materials.
Visit www.dymo.com for information on obtaining
labels and accessories for your label maker.
Warranty Registration
Please complete the warranty registration card and
return it to the appropriate Customer Support address
within seven days of purchase. Visit
www.dymo.com/registration for details.
Getting Started
Follow the instructions in this section to print your
first label.
Connecting the Power
The label maker can operate on AC or battery power. To
save power, the label maker will automatically turn off
after two minutes of inactivity.
Inserting the Batteries
The label maker uses six 1.5 volt high-capacity AA
alkaline batteries.
To insert the batteries
1. Remove the battery compartment cover.
See Figure 2.
Figure 2
2. Insert the batteries following the polarity
markings (+ and –).
3. Replace the battery compartment cover.
x Remove the batteries if the label maker will not
be used for a long period of time.
Connecting the Power Adapter
An optional AC power adapter can also be used to
power the label maker. Connecting the power
adapter to the label maker disconnects the batteries
as a power source.
To connect the power adapter
1. Plug the power adapter into the power connector
on the top, left side of the label maker.
2. Plug the other end of the power adapter into a
power outlet.
x Make sure the label maker power is turned off
before you disconnect the power adapter from the
main power source. Otherwise, your most recent
memory settings will be lost.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
