Dymo LabelManager 500TS Quick Reference Guide

2
Connecting the Power
The label maker is powered by a rechargeable, Lithium Polymer (LiPo) battery pack.
Inserting the Battery
The battery pack included with your label maker comes partially charged.
Make sure the charging adapter is disconnected before handling the
LiPo battery pack.
To insert the battery
1 Lift the back cover of the label maker.
2 Insert the battery into the battery compartment
following the polarity markings (+ and -).
3 Close the back cover of the label maker.
Make sure to read the LiPo Safety Precautions
found on page 15.
Removing the Battery
Remove the battery pack if the label maker will not be used for a long period
of time.
Make sure the charging adapter is disconnected before handling the
LiPo battery pack.
To remove the battery
1 Unplug the charging adapter.
2 Lift the back cover of the label maker.
3 Remove the battery from the battery compartment.
Make sure to read the LiPo Safety Precautions found on page 15.

Dymo LabelManager 500TS Specifications

Operating Environment

temperature resistance	-18° to 90° C

Weight and Dimensions

length	490 mm
width	311 mm
height	127 mm
weight	1102 grams