Dymo MobileLabeler - Inserting the Battery

3
EN
Inserting the Battery
The label maker uses a rechargeable lithium-ion polymer (LiPo)
battery and is shipped partially charged.
Make sure to read the LiPo Safety Precautions on page 6.
To insert the battery
Insert the battery into the battery
compartment as shown.
Close the cover.
Press to turn on the power.
Fully charge the battery as soon as
possible. The battery will take
approximately 2.5 hours to fully charge.
To charge the battery
Plug the power cord into the power
adapter.
Plug the power adapter into the
power connector and plug the
power cord into a power outlet.
!
1
2
3
1
2
Power connector