EasyManua.ls Logo

Dyna-Glo DGP397CNP-D - User Manual

Dyna-Glo DGP397CNP-D
93 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
Français p.
XX
Español p.
XX
Rev. 06/17/2019
3 BURNER
PREMIER GAS GRILL
Model #DGP397SNP / DGP397SNP-D /
DGP397CNP / DGP397CNP-D / DGP397GNP /
DGP397GNP-D / DGP397MNP/DGP397MNP-D
ATTACH YOUR RECEIPT HERE
Serial Number _____________________________ Purchase Date ______________________
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 1-877-447-4768, 8:00 a.m. – 4:30 p.m., CST, Monday – Friday
or e-mail us at customerservice@ghpgroupinc.com.
Français p. 32
Español p. 63

Table of Contents

Questions and Answers

  • M
    Mark CarpenterJul 25, 2025
    What to do if my Dyna-Glo Grill burner will not light with a match?
    • F
      francisco16Jul 25, 2025
      If the burner on your Dyna-Glo Grill won't light with a match, there are several potential causes. Ensure the match reaches the burners by using the match holder found in the cabinet door. Check the fuel level and replace if necessary. Also, examine the connection between the valve regulator and LP cylinder coupling, ensuring it is properly connected. Disconnect and reconnect if needed. Finally, the burner inlet may be blocked, so clean the burner inlet (venturi) and burner as described by the Care and Maintenance section in the manual.
  • K
    Karen WilliamsAug 2, 2025
    Why Dyna-Glo DGP397CNP-D has no gas flow or an obstructed gas flow?
    • D
      Daniel LoganAug 2, 2025
      If your Dyna-Glo Grill experiences no gas flow or an obstructed gas flow, several factors could be responsible. First, ensure the tank valve is fully opened by turning it counterclockwise. Next, check the fuel level and replace the fuel if necessary. Also, a poor connection between the valve regulator and LP cylinder coupling can cause this issue; turn off grill knobs, close the LP cylinder valve, and check/reconnect the connection if needed. Finally, a blocked burner inlet could be the culprit; clean the burner inlet (venturi) and burner as described in the Care and Maintenance section of the manual.
  • M
    Michelle LopezAug 9, 2025
    How to fix a Dyna-Glo DGP397CNP-D Grill burner that won't light with the ignitor?
    • M
      Michael CallahanAug 9, 2025
      If the burner on your Dyna-Glo Grill won't light using the ignitor, it could be due to a few reasons: the igniter electrode may be covered with grease or residue (clean the ignitor electrode); the igniter electrode may have a loose or disconnected wire (check the connection and reconnect any loose or disconnected wires); or the ignition electrode may be cracked or broken (replace ignition electrode, see Replacement Parts List).
  • M
    Mrs. Laurie Lee MDAug 16, 2025
    Why is my Dyna-Glo DGP397CNP-D having excessive flare ups?
    • T
      Tara AdamsAug 17, 2025
      Excessive flare-ups in your Dyna-Glo Grill can occur due to several reasons: a build-up of grease or residue on the heat tents or in the firebox (clean the grill components); excessive dripping of fat or marinade from food (trim the fat from meat and use non-oil based marinades); or the cooking temperature being too high (lower temperature accordingly).

Summary

Safety Information

General Safety Warnings and Precautions

Crucial safety advice including dangers, warnings, and cautions for grill operation.

Package Contents

Hardware Contents

Preparation for Assembly

Assembly Instructions

Operation Instructions

Care and Maintenance

Grill Cleaning and Maintenance

Procedures for cleaning grates, burners, surfaces, and general grill upkeep.

Troubleshooting

Troubleshooting Guide

Solutions for common grill operational issues and problems.

Limited Warranty

Replacement Parts List

Dyna-Glo DGP397CNP-D Specifications

General IconGeneral
TypeGas Grill
Fuel TypePropane
Cooking Area397 sq. in.
Burners3
MaterialStainless Steel
Burner TypeStainless Steel
BTU Output36, 000 BTU
Ignition TypeElectronic
Total Cooking Area507 square inches

Related product manuals