4
INSTALLATION
The heater may be used on an unnished oor. Place the
heater on oor or other at surface and insert plug into the
proper wall outlet.
WARNING: Do not place or use the heater on carpeting.
WARNING: To reduce the risk of re, do not store or
use gasoline or other ammable vapours and liquids in the
vicinity of the heater.
FLOOR APPLICATION
The EG4800DGP garage heater include a wall / ceiling
mounting bracket. The bracket should be mounted to
a structure that is capable of supporting the combined
weight of the heater and the bracket. Ideally, the bracket
should be secured to a wall stud, roof truss, or onto a
solid block wall using the proper mounting hardware. The
heater should be mounted as close to the power supply as
possible to avoid the use of an extension cord. Mount with
bottom of heater at least 2.4m / 8ft. above oor or grade
when mounting to a wall or ceiling.
1. Drill two holes in a wall/ceiling, the distance of the
holes should match the bracket.
2. Screw two M10*30 screws (not included) to wall/
ceiling, make sure the bracket is secured.
3. Hang the heater as shown below, secure the heater
to the bracket by inserting a bolt through a washer
(included) into the pre-drilled holes.
4. Secure the bolt with a lock washer and nut (included).
Tighten with a wrench.
WALL OR CEILING MOUNTING
CEILING MOUNT
WALL MOUNT
To Next Page
Loading...
