5
CIRCUIT DIAGRAM
OPERATING INSTRUCTIONS
WARNING: Do not tamper with the thermostat
or high limit.
WARNING: DISCONNECT POWER BEFORE SERVICING.
NOTE: Unplug the unit when not in use.
WARNING: The heater must be properly installed before use.
Set thermostat to its full counterclockwise position. Plug the unit into a properly
grounded 240V outlet. Set the thermostat to the farthest clockwise position. The fan
should come on and the unit will start heating the room. When the room reaches
comfort level, turn the thermostat counterclockwise until the heater turns off.
The heater will cycle automatically around this preset temperature. To increase
temperature, turn the thermostat knob clockwise. To lower temperature, turn the
thermostat counterclockwise.
Power Indicator lamp
Black wire
Black wire
Black wire
Black wire
Black wire
Black wire
Blue wire
Blue wire
Red wire
Red wire
White wire
Green wire
Caution Indicator lamp
Overheating
protection Switch
Blower Motor Heater
Heater’s
thermostat
LOW/BAS
OFF/ÉTEINDRE HIGH/HAUT
THERMOSTAT
To Next Page
Loading...
