Dyna-Glo IBF10PMDG User Manual

1
VENT-FREE BLUE FLAME
GAS ICE HOUSE HEATER
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED
EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY
DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED
EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING INJURY OR
LOSS OF LIFE.
WARNING: This appliance is equipped for
propane gas. Field conversion is not permitted.
- Do not store or use gasoline or other ammable vapors and Iiquids in vicinity of this or any other appliance.
- An LP cylinder not connected for use shall not be stored in the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Extinguish any open ame.
• Shut off gas to appliance.
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the re department.
-Installation and service must be performed by a qualied installer, service agency or the gas supplier.
This is an unvented gas-red heater. It uses air (oxygen) from the room in which it is
installed. Provisions for adequate combustion and ventilation air must be provided.
Refer to Air For Combustion and Ventilation section on page 7 of this manual.
This appliance may be installed in an aftermarket, permanently located, manufactured (mobile)
home, where not prohibited by local codes.
This appliance is only for use with the type of gas indicated on the rating plate.
This appliance is not convertible for use with other gases.
C US
C US
ANS Z21.11.2-2013
Gas Fired Room Heaters
Volume II - Unvented Room Heaters
CSA IR 4.98 U.S.
Gas Fired Room Heaters For
Recreational and Commercial Use.
IMIBF - 2015-08-14
Questions, problems, missing parts? Before returning to your retailer, call our customer
service department at 1-877-447-4768, 8:30 a.m. – 4:30 p.m., CST, Monday – Friday or
email us at customerservice@ghpgroupinc.com.
MODEL #
IBF10PMDG
IBF10PTDG

Dyna-Glo IBF10PMDG Specifications

General

BTU Output	10, 000 BTU
Fuel Type	Propane
Ignition Type	Piezo
Ventilation Required	Yes
Oxygen Depletion Sensor (ODS)	Yes

Summary

Important Safety Information

General Safety Precautions

Covers injury prevention, qualified service, cleaning, and handling warnings.

Carbon Monoxide and Gas Safety

Details signs of CO poisoning and safe handling of natural/propane gas.

Garage Installation Requirements

Specific Safety Guidelines

Accessory and Prop 65 Warnings

Prohibits unauthorized accessories and addresses California Proposition 65 and other operational rules.

Preparing for Installation

Air for Combustion and Ventilation Requirements

Details ventilation classifications and requirements for safe operation.

Determining Fresh-Air Flow

Worksheet to determine space volume and required fresh air for safe operation.

Ventilation Air Strategies

Methods for providing ventilation air from inside or outside the building.

Installation Instructions

General Installation Warnings

Covers supplemental use, qualified installation, clearances, and wall discoloration.

Clearances to Combustibles

Specifies minimum distances from heater to walls and furniture.

Wall Mounting Procedures

Instructions and warnings for mounting the heater bracket to the wall.

Mounting Bracket Attachment Methods

Details methods for attaching bracket to wall studs or expansion brackets.

Securing Heater to Mounting Bracket

Steps to attach spacers and place the heater onto the wall bracket.

Gas Supply Connection

Connecting Using Rigid Pipe

Checking Gas Connections and Pressure Testing

Connecting Using Gas Hose Assembly

LP Gas Cylinder Requirements and Handling

Connecting and Disconnecting LP Tank

Performing Leak Tests

Procedure for checking gas connections for leaks using a soap solution.

Operating the Heater

Safety Before Lighting

Manual Lighting Instructions

Thermostatic Control Operation

Pilot Flame Pattern Analysis

Burner Flame Pattern Assessment

Troubleshooting Guide

Ignitor and Unit Shutdown Issues

Pilot, Burner, and Flame Issues

Odor, Residue, and Noise Issues