7.3 STORE PROGRAMS AND PROGRAM NAMES
Whether you want to store an edited program, alter the name of a program, or copy a program from one
preset location to another - in all cases the necessary procedure is the same.
Pressing the STORE key (8) always starts and executes the saving procedure. You can also quit the
Store menu without saving your result by pressing any other key.
1. Press the STORE key (8) to start saving a program .
For instance, the display might look like this:
2. For saving the program without changing its name in the actual preset, proceed with step 6. If you
only want to change the program’s name and keep its location, proceed with step 4.
3. Use the rotary encoder (10) to select the desired preset location.
For instance, the display might look like this:
Please, proceed with step 6 if you do not want to change the program’s name.
4. Use the SELECT keys (5) and (6) to position the cursor to the first or the last character of the
program name. Now, the display indicates:
5. Use the rotary encoder (10) to select the desired character at the cursor position. Pressing the rotary
encoder enters a blank character at the actual cursor position. Use the SELECT keys (5) and (6) to
move the cursor between characters to be entered; e. g. “X-Over 200 Hz”. Program names can be up
to 16 characters long.
6. Press STORE (8) to acknowledge the selected program number and name. A safety dialog is
displayed asking you, if you want to save these changes.
7. The saving procedure is executed by pressing the STORE key (8) again.
OPERATION
7-4
To Next Page
Loading...
Need help?
General
