Dynacord DSP 244 User Manual

8.1 PARAMETER ACCESS
Depending on the actual configuration, only certain parameters are relevant. To provide a better overview
and prevent erroneous operation, in the STANDARD Edit mode only those parameters are accessible.
Additionally and to further improve operational comfort, corresponding parameters are linked. For
Instance, in the Stereo 2-Way configuration, the Master EQs, the Master delays, the outputs OUT1 / OUT3
and OUT2 / OUT4, and the X-Over parameters are linked for mutual setting.
For information about the parameters that are accessible with a certain configuration and parameters that
are linked, please refer to the following tables.
8.1.1 PARAMETER ACCESS-TABLE
STANDARD Mode
1)
FULL
EDIT
Mode
Stereo
2 Way
Stereo
2 Way /
Mono
Sub +
Fullrange
3 Way
+
Fullrange
3 Way
Mono
Sub +
Fullrange
3 Way
Independ.
Sub
+
Fullrange
4 Way
2-In-4
Full
Edit
ROUTING NO NO NO NO NO NO NO YES
IN2 EQs YES YES NO YES YES NO YES YES
IN2 Delay YES YES NO YES YES NO YES YES
IN1+2 Delay NO YES NO YES NO NO NO YES
Label NO NO NO NO NO NO NO YES
OUT1 HIPASS
XOVER
NO NO NO NO NO NO YES YES
OUT1 LOPASS
XOVER
YES YES YES YES YES YES YES YES
OUT2 HIPASS
XOVER
YES YES YES YES YES YES YES YES
OUT2 LOPASS
XOVER
NO NO YES YES YES YES YES YES
OUT3 HIPASS
XOVER
NO YES YES YES YES YES YES YES
OUT3 LOPASS
XOVER
YES NO NO NO NO YES YES YES
OUT4 HIPASS
XOVER
YES YES YES YES YES YES YES YES
OUT4 LOPASS
XOVER
NO NO NO NO NO NO YES YES
YES: Parameter is available
NO: Parameter is not available
1
) STANDARD Mode can be selected in the DSP 244 Editor software
PARAMETERS
8-2

Dynacord DSP 244 Specifications

General

Brand	Dynacord
Model	DSP 244
Category	Recording Equipment
Language	English