Rev. 01/11 - 2.7 - TFXL-X
The following list of information will be required before programming
the instrument. Note that much of the data relating to material sound
speed, viscosity and specific gravity are preprogrammed into the
TFXL flow meter. This data only needs to be modified if it is known
that a particular liquid data varies from the reference value. Refer to
Part 3 for data entry via ULTRALINK⢠software.
1. Transducer mounting configuration - see Table 2.2 on page 2.5
2. Pipe O.D. (outside diameter)
3. Pipe wall thickness
4. Pipe material
5. Pipe sound speed
1
6. Pipe relative roughness
1
7. Pipe liner thickness
8. Pipe liner material
9. Pipe liner sound speed
1
10. Fluid type
11. Fluid sound speed
1
12. Fluid viscosity
1
13. Fluid specific gravity
1
1
Nominal values for these parameters are included within the TFXL
operating system. The nominal values may be used as they appear
or may be modified if exact system values are known.
After entering the data listed above, the TFXL will calculate proper
transducer spacing for the particular data set. This distance will be
in inches if the TFXL is configured in English units and millimeters if
configured in metric units.
Important!
Enter All of the
Data on this
List , Save the
Data and Reset
the TFXL Before
Mounting
Transducers
PART 2 - TRANSDUCER INSTALLATION
To Next Page
Loading...
