Preparing the Site
3-3
Air and Electrical Requirements
The Model 8250 requires a compressed air supply of 85-95 psi (580-650 kPa). The
volume of air used is less than 1.0 SCFM (28 L/min at atmospheric pressure). A male
1/4 inch pipe thread fitting and a barbed fitting are provided for connecting the air supply.
The electrical power required is dependent on the specification given at the time of the
order. Available configurations are:
120Vac 60Hz 15A
100Vac 50Hz 20A
220Vac 50Hz 10A
220Vac 60Hz 10A
If you are unsure of the configuration, either contact Instron Dynatup or remove the back
panel to the rear motor enclosure to expose a label listing the required voltage.
To Next Page
Loading...