Initial Machine Operation and Checkout
3-11
(c) Press the ARM button. You should hear the audible alarm and see the red FIRE
button illuminate.
(d)
Continue to press the ARM button and press the FIRE button until the weight drops.
There may be a delay of 5 seconds.
(e)
Release the two buttons. If a pneumatic clamp is installed, the system will go
through a "stripping sequence" and then the latch assembly will automatically lower,
engage the crosshead, and raise to the position of the height limit magnet mounted on
the height scale.
(f)
Repeat the gravity drop several times and check that the crosshead hand knobs are
tight.
To Next Page
Loading...