Dynaudio Focus 60 XD - Remote Control Operations; Basic Remote Functions

15
dynaudio.com/focusxd
14
Remote control / Connecting the loudspeakersOwner’s Manual Focus XD
Remote control
The remote control can be used to turn the loudspeakers on and off, change the volume,
switch between digital and analog input, switch the display on or off, and select a hub and
its connected signal sources.
►
To connect the loudspeakers, switch all components off.
Connecting the digital signal source
You can connect your loudspeakers as follows:
•
Both loudspeakers are connected using cables. This requires two digital cables but the
systems benets from signal processing of 24 bits/192 kHz.
•
You only connect one loudspeaker using a cable; the connection between the
loudspeakers is wireless. This requires one digital cable and provides signal processing
capabilities of 24 bits/96 kHz.
•
Both loudspeakers are operated wirelessly via a Dynaudio Hub or Connect box with
signal processing of 24 bits/96kHz.
Connecting both loudspeakers with cables
1. Connect the digital output for the signal source to the digital input (Digital Audio IN) on
one loudspeaker. You can choose whether to use the right or left loudspeaker.
2. Operate the connected loudspeaker as master by setting the Channel Mode switch on
the rear side of the housing to Master.
3. Connect the digital output on the master loudspeaker to the digital input (Digital Audio
IN) on the other loudspeaker.
4. Operate the loudspeaker connected in this step as slave by setting the Channel Mode
switch on the rear side of the housing to Slave.
CONTROL ELEMENTS
MUTE
Muting the loudspeakers
Briey pressing this button will mute or unmute the selected
loudspeaker.
ON/OFF
Loudspeaker on/off
= on. = switch to standby
VOLUME
Changing the volume
= louder. = quieter
DIRECT
Direct selection
= toggle between digital and analog input
= switch the display on/off
INPUT
1/2/3/4
Selecting the signal source
Selects one of the signal sources Line In, Optical In, Coax In
or USB In from the active hub.
HUB
A/B/C
Selecting the Hub or Connect
Selects one of three possible Hubs or Connects A, B, or C.
Connecting the digital signal source.
Connecting
the
loudspeakers