To Next Page
R
rachel98Sep 18, 2025
Why the audio soundtrack and/or subtitle language cannot be changed on Dynex DX-24LD230A12 TV DVD Combo?
- MmlawrenceSep 18, 2025
The disc does not have multilanguage options encoded on it.
Why the audio soundtrack and/or subtitle language cannot be changed on Dynex DX-24LD230A12 TV DVD Combo?
The disc does not have multilanguage options encoded on it.
Why is my Dynex TV DVD Combo remote control not working?
If the remote control for your Dynex TV DVD Combo isn't working, check the following: * Ensure the power cord is correctly connected to both the TV/DVD combo and the power outlet. * Make sure there are no obstructions between the remote control and the remote control sensor on the front of the TV/DVD combo. * Point the remote control directly at the remote control sensor on your TV/DVD combo. * Verify the batteries are installed correctly. * Replace dead batteries with new ones.
What to do if there is good picture but no sound on Dynex DX-24LD230A12 TV DVD Combo?
If your Dynex TV DVD Combo has a good picture but no sound, try these steps: * Increase the volume. * Make sure that the sound is not muted. * Make sure that the correct audio mode is selected. * Check that the audio cables are connected correctly and securely to the back of your TV/DVD combo. * Verify the antenna or cable TV is connected correctly and securely. * If using an antenna, check the digital channel signal strength. * Try a new set of audio cables, as the ones you are using may be bad.
How to fix no power on Dynex DX-24LD230A12 TV DVD Combo?
If your Dynex TV DVD Combo has no power, check the following: * Ensure the power cord is correctly connected to your TV/DVD combo and a power outlet. * Unplug the power cord, wait 60 seconds, then plug the cord back in and turn on your TV/DVD combo. * Other devices (for example, surround sound receiver, external speakers, fans, or hair dryers) may be interfering with your TV/DVD combo. Try turning off one device at a time to determine which device is causing interference. Once you have determined which device is causing interference, move it further from the TV/DVD combo to eliminate the interference.
What does “ ” appearing on the screen of Dynex DX-24LD230A12 TV DVD Combo mean?
The function is not applicable to the disc or to the current mode.
How to fix dotted lines or stripes on Dynex DX-24LD230A12 screen?
If you see dotted lines or stripes on your Dynex TV DVD Combo screen, here are some troubleshooting steps: * Make sure that the antenna or cable TV is connected correctly and securely. * If you are using an antenna, the digital channel signal may be low. If the signal strength is low, adjust the antenna or use a highly directional outdoor antenna or set-top antenna with a built-in amplifier. * Make sure that the video cables are connected securely to the back of your TV/DVD combo. * The video cable(s) you are using may be bad. Try a new set. * Other devices (for example, surround sound receiver, external speakers, fans, or hair dryers) may be interfering with your TV/DVD combo. Try turning off one device at a time to determine which device is causing interference. Once you have ...
What to do if there are no channels after Auto Channel Search on Dynex DX-24LD230A12?
If there are no channels after performing an Auto Channel Search on your Dynex TV DVD Combo: * Reception can vary by channel depending on the broadcast power level of a given station. Contact your cable or satellite TV provider. * Make sure the antenna or cable/satellite TV is connected securely to your TV/DVD combo. * Try replacing the cable between the antenna/cable or cable/satellite box and your TV/DVD combo.
Why does picture distortion during fast reverse/forward playback happen on Dynex DX-24LD230A12 TV DVD Combo?
The picture will be distorted occasionally during fast reverse/forward playback on Dynex TV DVD Combo. This is not a malfunction.
Why does my Dynex DX-24LD230A12 TV DVD Combo have good sound but poor color?
If your Dynex TV DVD Combo has good sound but poor color, adjust the contrast, color, and brightness settings.
How to fix audio noise on Dynex DX-24LD230A12?
If you are experiencing audio noise with your Dynex TV DVD Combo, other devices (for example, surround sound receiver, external speakers, fans, or hair dryers) may be interfering with your TV. Try turning off one device at a time to determine which device is causing interference. Once you have determined which device is causing interference, move it further from the TV/DVD combo to eliminate the interference.
Safety tips for children's use of the display.
Crucial instructions for safe operation and handling.
Warnings regarding damage, condensation, and disposal.
Guide for first-time power-on configuration.
Setting restrictions and managing ratings.
Solutions for video, audio, remote, and disc issues.
General| Screen Size | 24 inches |
|---|---|
| Resolution | 1366 x 768 |
| Display Type | LED |
| DVD Player | Yes |
| HDMI Ports | 2 |
| USB Port | 1 |
| Audio Output | 2 x 5W |
| Refresh Rate | 60Hz |
| Display Technology | LCD |
| HDMI Input | 2 |
| USB Input | 1 |
| Built-in Tuner | Yes |
