Dynex DX-24LD230A12 User Manual (English)

Other manuals for Dynex DX-24LD230A12

Guía Del Usuario54 pages

Guide De L'Utilisateur54 pages

Quick Setup Guide2 pages

Guide D'Installation Rapide2 pages

Guía De Instalación Rápida2 pages

Specification Sheet1 page

Questions and Answers:

M
Mary BrownAug 26, 2025
How to fix no power on Dynex DX-24LD230A12 TV DVD Combo?
- L
  Lauren DavisAug 27, 2025
  If your Dynex TV DVD Combo has no power, check the following: * Ensure the power cord is correctly connected to your TV/DVD combo and a power outlet. * Unplug the power cord, wait 60 seconds, then plug the cord back in and turn on your TV/DVD combo. * Other devices (for example, surround sound receiver, external speakers, fans, or hair dryers) may be interfering with your TV/DVD combo. Try turning off one device at a time to determine which device is causing interference. Once you have determined which device is causing interference, move it further from the TV/DVD combo to eliminate the interference.
S
Shawn MathisAug 25, 2025
What to do if there is good picture but no sound on Dynex DX-24LD230A12 TV DVD Combo?
- E
  efitzgeraldAug 26, 2025
  If your Dynex TV DVD Combo has a good picture but no sound, try these steps: * Increase the volume. * Make sure that the sound is not muted. * Make sure that the correct audio mode is selected. * Check that the audio cables are connected correctly and securely to the back of your TV/DVD combo. * Verify the antenna or cable TV is connected correctly and securely. * If using an antenna, check the digital channel signal strength. * Try a new set of audio cables, as the ones you are using may be bad.
A
Ashley MartinezAug 25, 2025
Why is my Dynex TV DVD Combo remote control not working?
- S
  Stacy HillAug 25, 2025
  If the remote control for your Dynex TV DVD Combo isn't working, check the following: * Ensure the power cord is correctly connected to both the TV/DVD combo and the power outlet. * Make sure there are no obstructions between the remote control and the remote control sensor on the front of the TV/DVD combo. * Point the remote control directly at the remote control sensor on your TV/DVD combo. * Verify the batteries are installed correctly. * Replace dead batteries with new ones.

Dynex DX-24LD230A12 Specifications

General

Screen Size	24 inches
Resolution	1366 x 768
Display Type	LED
DVD Player	Yes
HDMI Ports	2
USB Port	1
Audio Output	2 x 5W
Refresh Rate	60Hz
Display Technology	LCD
HDMI Input	2
USB Input	1
Built-in Tuner	Yes