16
Large Extended Tilt Mount
www.dynexproducts.com
5 Align the wall plate on the wall mount with the anchor caps, insert the 1/4-20 x 1-3/4 in. screws through the 1/4 in.
washers, then through the holes in the wall plate. Make sure that the wall plate is level. Tighten the screws with a
Phillips screwdriver only until they are firm against the wall plate.
.
CAUTION: DO NOT over-tighten the screws.
Anchor cap
Wall plate
Screw and washer
To Next Page
Loading...
