Dynojet PCV - Page 6

25-010 www.powercommander.com 11-12 CanAm Spyder RT PCV - 6
19 Attach the ground wire of the PCV to the rear cylinder head on the left side
(Fig. K).
Remove the stock bolt and insert bolt thru the eyelet of the PCV ground wire and
reinstall bolt into head.
FIG.K
FIG.M
21 Plug the connectors from the PCV in-line of the stock wiring harness and crank
position sensor (Fig. M).
FIG.L
20 Locate the stock crank position sensor connector and unplug it (Fig. L).
This is a BLACK 2 pin connector on the left side of the engine.
PCV
PCV
Stk
Stk