Dynojet Target Tune - User Manual

Target Tune
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
98200071.09
1 TARGET TUNE MODULE
3 8” CABLE TIES
2 DUAL LOCK STRIPS
1 ALCOHOL SWAB
2 O2 SENSOR BUNGS*
1 ADAPTER CABLE**
2 18MM O2 SENSORS*
2 O2 SENSOR CABLES*
PARTS LIST
Installation and User Guide for:
Harley-Davidson
Parts shown with an asterisk (*) are excluded in Target Tune kits that have a part number ending in “X”. These kits are in-
tended for users that are upgrading from PV Auto Tune to PV Target Tune. These users should already have these specifi c
parts installed from the previous PV Auto Tune Kit.
Parts shown with two asterisks (**) are only used on 2021+ models with the 3-pin accessory port.

Summary

Parts List

Important Note

Introduction

Application Guide

Installation

Installation Continued

Installation Continued

Installation Continued

O2 Sensor Bung Installation

O2 Sensor Condition Test

Programming the ECM

Reading the ECM-Power Vision

WinPV Software-Target Tune

Applying Target Tune values using WinPV software for custom tuning.

Reading the ECU-Power Vision 3

C3 Software-Enable Target Tune

Enabling Target Tune using C3 Tuning Software for custom tuning.

Dynojet Target Tune Specifications