Dynojet Target Tune - Installation Continued

6 TARGET TUNE INSTALLATION AND USER GUIDE
98200071
INSTALLATION CONTINUED
2010-2019 Touring Models
The stock O2 connectors are found behind the right-
hand side cover.
2006-2015 Dyna Models
The stock O2 connectors for the front cylinder are found
at the front of the engine near the voltage regulator. The
stock O2 connectors for the rear cylinder are found under
the seat.
2007-2009 Touring and 2007-2011 Softail Models
The stock O2 connectors for the front cylinder are found
at the front of the engine near the voltage regulator. The
stock O2 connectors for the rear cylinder are found at the
rear of the engine near the oil tank.
Sportster Models
The stock O2 connectors for the front cylinder are always
at the front of the engine on the left side near the oil
fi lter. The stock O2 connectors for the rear cylinder are
above the battery on 2014-2015 models or just rear of the
engine on 2007-2013 models (not shown).
V-Rod Models
The stock O2 connectors for the front cylinder are always
on the left side of the radiator. You may need to loosen
the radiator shroud to gain access to it. The stock O2
connectors for the rear cylinder are found under the seat
near the fuel fi ller.
2012-2023 Softail Models
The stock O2 connectors for the front cylinder are found
at the front of the engine near the voltage regulator. The
stock O2 connectors for the rear cylinder are found under
the seat near the battery.
Rear O2
Street Models (500 and 750)
The stock O2 connectors for the front cylinder are locat-
ed on the right side of the bike between the swing-arm
pivot shaft and the engine case. The stock O2 connec-
tors for the rear cylinder are behind the left hand side
cover above the coolant reservoir.
Front O2
Front O2
Rear O2
Front O2
Rear O2
Front O2
Rear O2
Front O2
Rear O2
Front O2
Rear O2
Front O2
Rear O2
2020-2023 Touring Models
The stock O2 connectors are found behind the right-
hand side cover.
Rear O2
Front O2