7
9 Connect the supplied Y-adapter to the diagnostic port on the
motorcycle. (Refer to “Diagnostic Connector Locations” in the
Power Vision Quick Start guide for model specifi c diagnostic
connector locations.) Not needed on 2021 + models.
10 Route the connect the power lead from the Target Tune (TT)
module to one side of the Y-adapter.
•
2008-2011 V-Rod models will require splicing of the TT
module’s power and ground supply wires; or for a cleaner
install with OEM style connections a power extension lead
(PN: 76950159) can be purchased separately. If you are
splicing the power supply, the TT’s BLACK wire can go to a
constant chassis ground source such as the frame or the
engine case. The TT’s RED wire will need to go to a key-
switched 12v power source.
•
2011 Softail models will require splicing of the TT module’s
power and ground supply wires; or for a cleaner install
with OEM style connections a 6-pin Y-adapter,
PN: 76950389, and a 6-pin to 4-pin adapter, PN: 76950664,
can be purchased separately. If you are splicing the power
supply, the TT’s BLACK wire can go to a constant chassis
ground source such as the frame or the engine case. The
TT’s RED wire will need to go to a key-switched 12v power
source.
11 Connect the Power Vision diagnostic cable to the other side of
the Y-adapter.
Note: PV3 cable PN: 76951056 includes a CAN connector.
Make sure you do not connect the CAN connector to the
Target Tune.
12 Tie up and secure any loose sections of the wiring with the
supplied zip-ties and verify the wiring is free and clear of
abrasion and heat sources.
INSTALLATION CONTINUED
2021+ Touring Models
Plug the supplied power cable into the 3-pin accessory port on
the right hand side of the motorcycle and then into the Target
Tune module.
Connect the Power Vision cable to the other side of the Y-adaptor.
2021+ Softail Models
Plug the supplied power cable into the 3-pin accessory port on
the left hand side of the motorcycle and then into the Target Tune
module.
To Next Page
Loading...
